Flexconnect CLI Configuration

[j.eduardog]

Hello

Trying to configure Flexconnect configuration via script but it is not working, anyone got the same problem?

(Cisco Controller) >config ap mode flexconnect AP1

Changing the AP's mode will cause the AP to reboot.

Are you sure you want to continue? (y/n) y

After AP rejoins...

(Cisco Controller) >config ap flexconnect vlan enable AP1

Request failed: flexconnect in the enabled state.

Then cannot apply any other flexconnect command since I cannot enable vlan support

[Scott Fella · Accepted solution]

You need to admin down the ap before you am run that command.

Sent from Cisco Technical Support iPhone App

[Scott Fella]

Did you get the command to take? I do this all the time when with no issues.

Sent from Cisco Technical Support iPhone App

[j.eduardog]

Thank You,

Command:

config ap disable ap_name

[Scott Fella]

Yup that's it... Don't forget to enable the ap:)

Sent from Cisco Technical Support iPhone App