Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys,
After initial setup of prime 3.1 on a physical appliance Gen2, I tried to update to 3.1.7 (PI_3_1_7-1.0.16.ubf) through web using local drive from my laptop and I am getting the following message:
An error occurred while uploading file:...
Hello guys,
After downgrading from 5.1.1 to 4.3.4 it shows me that I need to upgrade 0/BPID0/SP Location but I can not find a way to do it, is there any other procedure to do that? here are some outputs when I tried to upgrade the location 0/BPID0/SP...
Hello guys, I have two DCs, they are separate buildings, each one has its own Foreign (8510) and Anchor (5508) controllers, they have HA peering controller, but DC1 and DC2 are not in the same mobility group. Currently Anchor on DC1 connects only to ...
Hello guys,Has anyone already changed high availability on Prime from Local to Campus mode? I am going to decomission the secondary Prime and associate a new one in a remote site, is that simple as: 1-Decomission current secondary Prime server2-Assoc...
Hello guys,I already have a ISE implemented in distributed mode and would like to create a new set of VMs on a new data center, making the new data center the Admin/Monitor primary leaving the old data center as Admin/Monitor secondary. Will I need t...
