FLEXConnect over IPSEC

James Hoggard · ‎03-19-2014

Hi,

I have a IPSec site to site VPN.

at our main office we have a WLC 2500 series.

we have just deployed an AP ( AIR-CAP3602I-E-K9 ) in flex connect mode at our branch office. The WLC at the main office can see it, however no clients seem to be connecting. The DHCP server is local on the spoke site i thought it would just work. Is there anything i need to set in the WLC to get this working?

Thanks

Sandeep Choudhary · ‎03-19-2014

did AP joined to WLC???

please check this guide :

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/71250-h-reap-design-deploy.html

Regards

James Hoggard · ‎03-20-2014

Yes the ap has joined the WLC over IPSEC vpn. Just looking at the link you sent me local switching has to be done in standalone mode not flex connect is that correct?

Thanks

Sandeep Choudhary · ‎03-20-2014

Which state you want to apply, its depends on that:

Central Authentication, Central Switching
Authentication Down, Switching Down
Central Authentication, Local Switching
Authentication Down, Local Switching
Local Authentication, Local Switching

Check the config for each:

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/81680-hreap-modes.html

Regards

Dont forget to rate helpful posts