FlexConnect Vlan Mapping

[awatson20]

5508 WLC on 7.3. For locally switched WLANS, when configuring FlexConnect Vlan Mappings, concerning the native vlan, can this vlan also be used as a vlan mapping for an SSID or not?  This would mean that the mgmt IP of the AP's, and this particular SSID would be on the same network. 

[awatson20]

This is a small branch site with only 2 vlans 1 for data and 1 for voice.  Do not want to create another network just for a few AP's.

[Scott Fella · Accepted solution]

Yes... If your ap and users are going to be put in the data Vlan, you can just leave the port to an access port and you don't have to setup any native val. Or Vlan mapping in the FlexConnect AP. If you decide you want to map users to the voice Vlan, then you need to trunk it.

If you want to trunk it anyways, then you can map a WLAN to the data Vlan too.

Sent from Cisco Technical Support iPhone App

[awatson20]

Thanks again Scott.  That is what we thought just making sure.  We wanted the 7925 phones to be on the local voice vlan, so we went ahead and trunked.

[Scott Fella]

No problem!

Thanks,

Scott

*****Help out other by using the rating system and marking answered questions as "Answered"*****