Getting started with 3850 as WLC - Wireless GUI fails

[roger perkin]

I have started to look into configuring our 3850 as a WLC

I enabled the command wireless mobility controller

Then I tried to connect to <switch ip>/wireless

I just get a dead page.

I configured the wireless management vlan but still no joy

What basic steps am I missing?

Thanks

Roger

[Sandeep Choudhary]

1. Make sure this are aenabled on this:

ip http secure-server

ip http server

2. Also Enable WIreless Management

            3850(config)#wireless management interface vlan <1-4095>

3. Normally You can access wireless controller GUI using https:///wireless URL.

Please check these docs, it may helps.

https://supportforums.cisco.com/docs/DOC-34430

http://mrncciew.com/2013/09/29/getting-started-with-3850/

Please go through these, u will resolve ur problem.

Regards

Dont forget to rate helpful posts

[Rasika Nayanajith]

Hi Roger,

Make sure you have latest IOS-XE code (3.3.1) as older codes had some issues.

Even with that code GUI is not that reliable & CLI would be the best way for the time being.

HTH

Rasika

**** Pls rate all useful responses ****