cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Bookmark
|
Subscribe
|
2146
Views
30
Helpful
5
Replies

Guest reauth. again and again

ittechk4u1
Level 4
Level 4

Hello Experts,

I configured CWA (WLC / ISE) and its working but...Guest users are complaining about re-authentication again ad again after few minutes.

 

can anyone help about it ?

Thanks

 

2 Accepted Solutions

Accepted Solutions

Sandeep Choudhary
VIP Alumni
VIP Alumni

Hi,

check these:

1. Did you disable session timeout(by default 1800) on WLAN or did you increased it (8x60x60seconds)!!!

2. How did you configured your authZ policies ?

  - Here you can send idle timeout and sessiontimeout with RADIUS Attributes!!!

 

Regards

Dont forget to rate helpful posts

 

View solution in original post

ok. Then you push Idle Timeout/session-timeout radius attribute from AutZ profile and try again.

Check this pic:

162848-Screen Shot 2013-10-18 at 8.28.11 PM.png

 

 

 

Regards

Dont forget to rate helpful posts

View solution in original post

5 Replies 5

Sandeep Choudhary
VIP Alumni
VIP Alumni

Hi,

check these:

1. Did you disable session timeout(by default 1800) on WLAN or did you increased it (8x60x60seconds)!!!

2. How did you configured your authZ policies ?

  - Here you can send idle timeout and sessiontimeout with RADIUS Attributes!!!

 

Regards

Dont forget to rate helpful posts

 

Thank you Sandeep.

Yes I disabled the session timeout still facing the same issue..

 

 

ok. Then you push Idle Timeout/session-timeout radius attribute from AutZ profile and try again.

Check this pic:

162848-Screen Shot 2013-10-18 at 8.28.11 PM.png

 

 

 

Regards

Dont forget to rate helpful posts

Ok I will add these parameter and let you know the results.

 

Thanks again for quick answer.

Thanks you sandeep, its working.

 

 

Review Cisco Networking for a $25 gift card