10-30-2013 12:04 AM - edited 07-04-2021 01:10 AM
Hi all,
I need to do some HA setup between two Cisco 8510 controllers.
I only have the opportunity to connect the two redundant ports with 100 mbps switch link. Wil it work, or MUST it be gigabit connection?
The two 8510 will replace 2 x 5508, which today is used and is connected via 100Mb switch link.
By the way, what will happen to the HA WLC if its just the link between the 2 WLC that goes down. Will it start being active, although the primary actually still is active and it's just a redundant link that has gone down?
Regards. F
10-30-2013 07:55 AM
How do you have the 5508's connected to a 100 Mbps port, they are gigabit only.
Sent from Cisco Technical Support iPhone App
10-30-2013 09:37 AM
No. It must be 100/1000 or maby even 10/100/1000.
This is the setup. I plan to replace the 5508 with 2 x 8510 and hope to use the same Access-link.
10-30-2013 10:00 AM
Well it will work as long as it's gigabit. The 8500 has two 10gig ports though.
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide