Wireless

Hello, We're performing throughput tests on EPC3928S-1CC-K9. One of the test is single file FTP transmission. The modem is connected to 8 channels, Annex A wideband interface, 4 US bonded.While tests we cannot exceed 100Mbps throughput when transmitt...

Hi, please give us newest firmware for EPC3928-4041694-K9 version E10-5.Regards,Grzegorz Cegielski

Hello. This is a quick question about text messages to 7925. In my case is working just fine, we receive the text messages and we can read them, but is there a way to save them and read them again later.Once we read it seems to be deleted, because we...

2504 wlc, 3602 ap, 802.1 x authentication, local DB, no RADIUS or TACACS+ servers.iPad and Android phones can connect but Windows 8.x clients cannot.Get a limited message for a few seconds beneath the SSID on Windows 8.x. below Status on Windows Netw...

Outside of the fact that one is rated for outdoor use, what are the differences between a 3602 and 1530?   Also, is there any benefit in just putting a 3602e in an enclosure over using an outdoor rated 1530? Thanks

I see that both get used frequently. My WLC does not seem to support the top one: config network ap-mcast-mode multicast 239.239.239.239config network multicast mode multicast 239.239.239.239  Thanks

HiI am looking for wireless access point to provide internet service but it should be has DHCP server to provide IP addresses for clients because I would like to separate the clients from main LAN.best regardsOsama

Hi All, What is the use of Web auth proxy redirection ? Is it the way to monitor web auth traffic & allows it to go via proxy..?  

I have a couple of 1142 AP's running autonomous IOS (latest 15.3(3)JBB).  They are showing 100% CPU constantly, although I can't see what process is causing it:ap1142n-gnd#sho proc cpuCPU utilization for five seconds: 100%/0%; one minute: 100%; five ...

I have a customer running 7.6 on a 5508 and are applying new licensing. They can apply the licensing but after a controller reboot the licenses are gone. I've informed them to open a TAC case but thought I'd post on the community to see if someone ou...

Hi,is it required to press any key after restarting a virtual controller on VM console?If yes, is there an option to automating this process so that the controller starts without pressing a key. thanksMartin

I am trying to add floor plans using Prime infrastructure does anyone know of a document or website that shows how to do this? I have MSE installed.Thanks!