Help with config of a new 1832i access point

[itnsengineer]

Just purchased a new 1832 access point to work as a single stand alone AP for a small office.  I have it configured and can access the controller website.  I have the SSID's set and clients can connect to the AP with network and internet access.  My question, the LED on the unit is flashing red, green, amber, blank quickly repeatedly.  I understand that this has something to do with the controller searching for other access points. There will be no other AP's at this location.  How do I change the behavior of the LED to act as a stand alone AP and only show green?

This is the first time I have worked with this model and software so I am very new to the interface.

[Philip D'Ath]

Green insulation tape or green masking tape.  Fixed.

[itnsengineer]

While I appreciate the band-aid solution, there must be a command to disable the access point from searching via the command line possibly. All the guide tells me is that this pattern of lights indicates that "Access point location command invoked from controller web interface".  I'm not even sure what that means.