10-08-2014 02:21 PM - edited 07-05-2021 01:41 AM
Hi
I have a problem with my ap the model is 3702i, when I turn up the access point and I connect to the cable console. The access point show this in the output:
ÿÿÿÿ
Any suggestions?
Thanxs for the help
10-08-2014 04:25 PM
Makesure your console settings are correct (check whether you can access any other devices console without any problem)
If you are sure, console is working, but 3702 give that type of output you can try to reset 3702 settings to factory default & load a recovery image from a TFTP using mode button method.
Step 1: Assign static IP address to your PC/TFTP of 10.0.0.2/8 with Gateway 10.0.0.1
Step 2: Download (ap3g2-rcvk9w8-tar.152-4.JB6.tar) from Cisco & rename it as ap3g2-k9w7-tar.default & put it in TFTP server.
Step 3: Connect the PC to the access point using a Category 6 (CAT6) Ethernet cable.
Step 4: Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point.
Step 5: Press and hold the MODE button while you reconnect power to the access point.
Step 6: Hold the MODE button until the status LED turns red (approximately 20 to 30 seconds), and release the MODE button.
Step 7: Wait until the access point reboots as indicated by all LEDs turning green followed by the Status LED blinking green.
Step 8: You can monitor the console output to see if that loading the proper image.
10-09-2014 08:59 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide