How to check Flexconnect mode (connected & standalone)

[JustTakeTheFirstStep]

Perhaps the 2700 series was able to check the mode with the show capwap reap status command.

However, the 2800 series does not have that command.

show capwap reap status

AP Mode: REAP, Connected

show capwap reap status

AP Mode: REAP, Standalone

How to check Flexconnect mode??

[ammahend · Accepted solution]

try show flexconnect status —Shows the status of the FlexConnect access point (connected or standalone). 
I don’t have a 2800, but I tested it on 3800.

hope this helps