How to check the RP port on 9800-L-F controller to see if active

[dkpzania]

How can I check the RP port status on the WLC 9800-L-F controller?  I can use the command below on the 9800-40 WLC and it shows whether there is an active link on the RP port, how can I do the same for the 9800-L-F controller?

sh platform hardware slot R0 ha_port interface stats HA Port

ha_port Link encap:Ethernet HWaddr x:x:x:x:x:x
inet addr:169.254.109.63 Bcast:169.254.109.255 Mask:255.255.255.0
inet6 addr: xxxxxxxxxxxxxxxxxx/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:2065137475 errors:0 dropped:0 overruns:0 frame:0
TX packets:2041701691 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:877526587894 (817.2 GiB) TX bytes:794313963839 (739.7 GiB)
Memory: x-x

[marce1000]

   - The same command should work on the  9800-L-F controller too
      If you use an SFP connection you also have :  show platform hardware slot R0 ha_port sfp idprom
     (show details of SFP in SP)
      In case of an active HA-SSO pair , you can also use : test wireless redundancy rping

  M.

[dkpzania]

After reloading I see the following interface tw0/0/0 is what is actually connected and not the RP port...still need a way of checking whether there is an active link on the RP port 

[MHM Cisco World]

Show plat soft rif-mgr chassis active R0 resource-status 

MHM