I would like to configure 3 Access Point (WAP4410N) to extend the wifi in my house. I try it to do several configuration but it doesn't work.
In this configuration, the wifi devices disappears and re-appears constantly. I lose the IP addresses and they all come down only every 5 seconds.
I made screen shots of the 3 terminals in the word document attached below. Can you help me please
In order for an AP to work in repeater mode, there must be 50% overlap on the signal and the APs must be on the same channel. For each repeater that is setup the actual throughput is roughly half.
Ok So I changed the configuration about the wireless. I plugged every AP with wire and I have configured it as AP with the same SSID.
I think is the better configuration for actually.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: