How to disable POE negotiation on 9124AXI?

[SondreSandberg]

I've connected 9124AXI on a POE+ switch and the AP is complaining about that it wants UPOE, but POE+ is good enough.
The thing is that this causes the LED to flash between red and green because it's complaining about not enough power.

Planning on using this 9124AXI on a POE+ switch, so is there any way to configure the AP to not try to go for UPOE and be happy with POE+?

The AP is connected to a 9800 WLC running 17.3.4C

Aug 4 11:52:19 powerd: cdp0: CDP PoE negotiation START
Aug 4 11:52:19 powerd: cdp0: CDP PoE in_packet_cnt:86
Aug 4 11:52:22 powerd: cdp0: CDP UPoE required but not supported by PSE/Switch
Aug 4 11:52:22 powerd: sending powerd message
Aug 4 11:52:22 powerd: send ipc_socket_process: 4
Aug 4 11:52:22 powerd: ps: Power mode: Degraded/Reduced Power, power_detection: DC_adapter(FALSE), PoE+/802.3at(30000 mWatt)
Aug 4 11:52:22 powerd: ps: End: System running on low power @ 30000 mWatt from port0

[marce1000]

                          >.... System running on low power @ 30000 mWatt from port0

 So it seems that the AP , is already happy. Is it functional and or can it be used in this 'configuration' despite the led warnings.

 M.

[SondreSandberg]

It can completely be used, it just uses 2x2 SS on 2,4Ghz and 5Ghz radio.
I'm considering just disabling the LED light.

[marce1000]

           - That's normal indeed ,  correct to disable led light , if so desired

 M.

[Leo Laohoo]

Disable the USB port and get an extra 4.0wac back.

[Rich R]

I suspect disabling LED will be your only option.