12-14-2011 12:54 PM - edited 07-03-2021 09:14 PM
Hello guys,
I have the next escenario, 9 APs 1142 installed that at the same time they connect a one RADIUS server to secure the network,
(Wireless clints -- APs -- RADIUS server -- Aplications/Internet )
Now, we have to add another RADIUS Server, this is in case of the primary server falls, the other one comes in action, the configuration
has been made, however has not bee tested, we can not shut down the primary RADIUS server this is because it
cointains more applications, one way that could test if the backup radious server si working, is to delete of the configuration the primary
radious server, how can I know if the backup server is working? exist one command in the IOS of AP to know if the RADIOUS server is working??..
Regards!
Solved! Go to Solution.
12-14-2011 01:09 PM
How about "sh aaa servers"?
12-14-2011 01:09 PM
How about "sh aaa servers"?
12-16-2011 07:44 AM
Thanks Guys,
We have some problems.. no Cisco problems... problems about radious servers.. but now it is 0.k.
12-14-2011 01:49 PM
if this is an IOS setup you can use the test command:
test aaa group radius blahblah blahblah new-code
**blahblah being he username and password you want to send. It doesn't have to be valid, just need a response.
HTH,
Steve
----------------------------------------------------------------------------------------------------------
Please remember to rate helpful posts or to mark the question as answered so that it can be found later.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide