cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
898
Views
5
Helpful
1
Replies

How to reset a 140AC wireless network?

aline.serio
Beginner
Beginner

Hi,
We have connected 2 new wireless terminals to our infrastructure and we could only configure one of them.


The second one is visible in our DHCP and flashes green quickly but we can't connect to it because the SSID doesn't show up in the wireless network.

 

Why can't we connect to it?
How to reset it?

 

Thanks

1 Accepted Solution

Accepted Solutions

jagan.chowdam
Participant
Participant

If your access point isn’t new, out of the box, make sure it is reset to factory default settings for the CiscoBusiness-Setup SSID to show up in your Wi-Fi options.

 

Use the following link to see the steps for factory reset.

https://www.cisco.com/c/en/us/support/docs/smb/wireless/CB-Wireless-Mesh/2120-reset-to-factory-default-cbw.html

 

CJ

 

/** Please rate all useful responses **/

View solution in original post

1 Reply 1

jagan.chowdam
Participant
Participant

If your access point isn’t new, out of the box, make sure it is reset to factory default settings for the CiscoBusiness-Setup SSID to show up in your Wi-Fi options.

 

Use the following link to see the steps for factory reset.

https://www.cisco.com/c/en/us/support/docs/smb/wireless/CB-Wireless-Mesh/2120-reset-to-factory-default-cbw.html

 

CJ

 

/** Please rate all useful responses **/

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: