How to set Static IP Address for cisco APS in controller via command line

[syed baseeruddin]

Hi

in our project there 208 APS  registered in a wism-1 controller

how i have to assign static ip address to this Aps via command line in a controller 4404 

through web it takes more time to assign static ip

[M. Wisely · Accepted solution]

You don't mention what version of code you're on but on 7.0:

config ap static-IP enable <AP Name> <IP> <Mask> <Gateway>

You can also add

config ap static-IP add domain <AP Name> <Domain>

config ap static-IP add nameserver <AP Name> <DNS IP>

[syed baseeruddin]

Thanks Martin Wisely ,

System Information
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.0.252.0
RTOS Version..................................... 7.0.252.0
Bootloader Version............................... 7.0.252.0
Emergency Image Version.......................... 7.0.252.0
Build Type....................................... DATA + WPS