How to Turn on Radio on 1522E AP With 2504 WLC

[rcowan]

I have a 2504 WLC with two 1522 AP's one is Root the other Mesh the 802.11b/g/n/     Admin Status says Up but the Operational Status says down. How can I turn this on? When I change the Admin status to enable I get a "Error in  Enabling Admin Status" 

[Saravanan Lakshmanan]

Looks like you're not using right power supply/source. use right power injector and try.

get traplog from WLC.

[rcowan]

Thanks for the Response.

I was thinking the same thing, a power problem and even swapped the POE with a new one.

We have over 40 sites up with the metal POE80U-560(G)-C-R injectors.

I will try to get a Traplog form the WLC and get it posted.....

[rcowan]

Trap Log results

Hope this is enough...

[Saravanan Lakshmanan]

1552E supported poe - 56 VDC power injector AIR-PWRINJ 1500-2= only.

[Karthikeyan-Gunasekar]

Hi Saravanan,

But the POE80U-560(G)  is the same specs as the cisco AIR-PWRINJ 1500-2=, then why the 1552E doesnt power up. PoE injectors are just silent devices to feed power.

In case where we have one power source and 5 Access Points in the same IDF location, we have used 95W/Port switches to power the 1552E access Points.

Appreciate your reply.

Karthikeyan

Solution Architect (ICT Business)

[Chris Illsley]

Hi,

You have configured the power injector on the AP?

Wireless -> Select AP -> Advanced

Power Over Ethernet Settings

- Power Injector State enabled

Thanks

Chris

[Karthikeyan-Gunasekar]

Hi Mooncat76,

We tried these option, still the PoE injector doesnt detect the Access Points.