How to upload image file via CLI? Aironet 1310

[ap1310]

Aironet 1310, injector LR2, Win 10 PC with ethernet and serial ports

Cannot access the 1310 via ethernet, can only access via PC's serial port (to injector LR2's console port. )

When booting gives an error, I will post details later, something about 

              .........invalid value at RTS threshold ^...................

for now want to learn how load image file via serial port.

Setup used to work fine but suddenly this issue, changed network cables, PCs, etc. but problem persists. I don't have another injector. Link cables between 1310 and LR2 tested ok.

Researched for an answer, but instructions show how to tftp the image via ethernet only.

I know its slow via serial but updating the image is what I want to try.

[Rasika Nayanajith]

Before changing image, would you be able to post what you see in console when AP is power cycle.Save it as .txt file and attach here.

HTH

Rasika

[ap1310]

File attached. In case attachment doesn't work here is one error

rts threshold 4000
^
% Invalid input detected at '^' marker.

[Rasika Nayanajith]

 it looks like AP booted but with no configuration. If you type "enable" does it prompt password?

Rasika

[ap1310]

Yes. Every command I give over serial port works out, just can't connect via network jack.

I can interrupt boot by pressing Escape and get into bridge prompt

[Rasika Nayanajith]

Do you have the previous configuration of this AP? If so you can re-apply that config. Pls share it (without password) with us if you would like us to check.

If you cannot reach it from ethernet, pls share switchport configuration where it is connected to as well

Rasika

[ap1310]

No configuration. Just need it back to all reset.

So I want to put new image and start from there, maybe Ethernet port will then work

[Rasika Nayanajith]

if that is the case, simply try below and connect bridge to DHCP enable switch port

int bvi1

ip address dhcp

if that does not work, you can assign IP address manually

int bvi1

ip add x.x.x.x

!

ip default-gateway x.x.x.y

As long as bridge connect to access port on the same vlan (same IP subnet you configured for AP) it should work

HTH

Rasika

[ap1310]

Tried the first line you gave, didn't work at bridge: or ap> or ap#
---

ap>int bvi1
^
% Invalid input detected at '^' marker.

ap>ena
Password:
ap#int bvi1
^
% Invalid input detected at '^' marker.
-------------------

bridge: int bvi1
Unknown cmd: int

[Rasika Nayanajith]

You have to go to configuration mode

ap>enable
ap#config t

ap(config)#int bvi1

ap(config)#ip address dhcp

ap(config)#exit

ap#write mem

HTH

Rasika

[ap1310]

Problem with ethernet port persists.
Where to dl manual with all the commands? Then I could experiment, maybe find the solution
I only got the commands in the Cisco Aironet 1300 Configuration Guide

This error has gone away
.........invalid value at RTS threshold ^...................

[Rasika Nayanajith]

can you post the switchport config where this AP connected? "show run interface x/x" if it is a cisco switch

HTH

Rasika