Hi All,
I am currently using as 4402 with 6.0.196 image. The APs that i am using is the 1130.
I have configure HREAP for Local switching, it works very well. I am even able to do 802.1x
Authentication after registering with ACS. Currently I am usng only 1 SSID. That SSID is mapped
to vlan 10 and my AP is on native Vlan 1.All the proper trunks and routing has been enabled.
The issue i have is that when I am trying to create a central switched WLAN that fallbacks to local
switching once the controller is down. The only diffrerence I made was to remove the "tick"/checkbox option
for "local Switching" on the WLAN page.
It is able to work if the controller is up, I am even able to get the IP network where the controller resides. However when
i tested by disconnecting the controller, The client is unable to authenticate or send traffic anymore. I've tried using WPA-PSK
and also WPA-PEAP-MSChapv2. Both fails miserably.
Does this mean that I need to create 2 WLANs? One for Local Switching and the other for Central Switching on the HREAP mode
APs.Cant i do it with just a single WLAN?
Thank you.
Warmest regards,
Azzafir Ariff Patel.