I accidentally added an interface to the wrong interface group on 5508

bjohnson04 · ‎06-16-2022

I accidentally added an interface to the wrong interface group

Interface abc to our guest interface group. I tried disabling the abc WLAN and then removing it from the group but that didnt work. Im still get the error "Interface group is being used by WLAN"

What do I need to do to remove this interface?

Rasika Nayanajith · ‎06-16-2022

Temporary map different interface to WLAN (under AP group & global WLAN config) & then go under interface group & remove the unwanted interface. Then you can remap the interface group to the WLAN

HTH

Rasika

*** Pls rate all useful responses ***

magNHS · ‎11-24-2023

Hi @Rasika Nayanajith

What is the impact of perform the suggested action?

I assuming that this will lead to WLAN being unavailable while the interface group is remapped causing outage!

Rich R · ‎11-24-2023

Yes obviously so should be done during a maintenance window @magNHS

------------------------------
Please click Helpful if this post helped you and Select as Solution (drop down menu at top right of this reply) if this answered your query.
------------------------------
TAC recommended codes for AireOS WLC's and TAC recommended codes for 9800 WLC's
Best Practices for AireOS WLC's, Best Practices for 9800 WLC's and Cisco Wireless compatibility matrix
Check your 9800 WLC config with Wireless Config Analyzer using "show tech wireless" output or "config paging disable" then "show run-config" output on AireOS and use Wireless Debug Analyzer to analyze your WLC client debugs
Field Notice: FN63942 APs and WLCs Fail to Create CAPWAP Connections Due to Certificate Expiration
Field Notice: FN72424 Later Versions of WiFi 6 APs Fail to Join WLC - Software Upgrade Required
Field Notice: FN72524 IOS APs stuck in downloading state after 4 Dec 2022 due to Certificate Expired
- Fixed in 8.10.196.0, latest 9800 releases, 8.5.182.12 (8.5.182.13 for 3504) and 8.5.182.109 (IRCM, 8.5.182.111 for 3504)
Field Notice: FN70479 AP Fails to Join or Joins with 1 Radio due to Country Mismatch, RMA needed
How to avoid boot loop due to corrupted image on Wave 2 and Catalyst 11ax Access Points (CSCvx32806)
Field Notice: FN74035 - Wave2 APs DFS May Not Detect Radar After Channel Availability Check Time
Leo's list of bugs affecting 2800/3800/4800/1560 APs

Flavio Miranda · ‎06-16-2022

Hi

Hopefully you dont have this interface group added to many AP group . I did the same mistake already and I had the interface group in about 100 AP groups. I had to use a spreadsheet to run all AP group deleting and interface group. Then taking off on interface and adding the interface group back in all AP groups again.