I want to Configure PPPOE Internet Dial-up from ISP on Cisco 2500 WLC,

[fardeen ansari]

I am using Cisco 2500 series WLC with 2 access point and i want to run Internet which is PPPOE dial-up Connection, i need refference Configureation for start my Internet,

[Saurav Lodh]

Refer

https://supportforums.cisco.com/thread/2233547

and

http://www.cisco.com/en/US/products/ps11630/products_tech_note09186a0080b8450c.shtml

[Leo Laohoo]

i want to run Internet which is PPPOE dial-up Connection,

Not going to happen.

WLC cannot do routing much less NAT.  So you need a router that faces the ISP and your WLC connects to the router.

[fardeen ansari]

Thanx dear,

Its means i have to use router for internet and than router to WLC,

Is it possible i can assign IP to acces point from WLC, I dont have DHCP server, I configure WLC as DHCP mode..

[Leo Laohoo]

Its means i have to use router for internet and than router to WLC,

This is correct.

Is it possible i can assign IP to acces point from WLC, I dont have DHCP server, I configure WLC as DHCP mode..

Yes you can too.  But if you are going to require a router for your ISP, then why not move the DHCP function to your router? 

[fardeen ansari]

than what about power source I bought WLC 2500 with POE can i connect my AP with these ports directly....