06-02-2008 11:54 AM - edited 07-03-2021 03:58 PM
Hi all,
I posted another question about not being able to get my 1200 working with clients but I think I need to take a step back and take a closer look at my initial setup. I have this AP on a switchport but after thinking about this, I have vlans I wish to also have on the AP. Can this AP be put on a trunked port just like a switch? If so, how does this work? I have done the setup of the trunked port and the associated sub interfaces on the AP but cannot get a successful link. Can someone shed some light on this config?
06-03-2008 01:07 AM
06-03-2008 04:56 AM
Thanks for your reply. I have followed these guides and believe I have a working initial setup. The radio interface is up up and I have configured it to work with my windows IAS but I am still unable to connect from my clients. does my config look like it would be a working config?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide