cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
4146
Views
0
Helpful
2
Replies

Interface Dot11Radio0, Deauthenticating Station Reason: Sending station has left the BSS

mohamedjalil
Level 1
Level 1

Dear сolleagues,

I have a problem with 3 AP AIR-SAP1602I-E-K9:

Interface Dot11Radio0, Deauthenticating Station xxxx.xxxx.xxxx Reason: Sending station has left the BSS

i have WPA / TKIP and i update the drivers on our laptops and i try a lot of solutions but the problem persists 

this is my configuration :

 

!
! Last configuration change at 21:22:36 UTC Wed Mar 3 1993 by Cisco
version 15.2
no service pad
service timestamps debug datetime msec
service timestamps log datetime msec
service password-encryption
!
hostname AP1
!
!
logging rate-limit console 9
enable secret 5 $1$MNKV$SsjzhDbJ2be4LpcUAErZD1
!
no aaa new-model
no ip routing
no ip cef
!
!
!
dot11 syslog
!
dot11 ssid FORAMAG
   vlan 1
   authentication open 
   authentication key-management wpa
   mbssid guest-mode
   infrastructure-ssid optional
   wpa-psk ascii 7 06570B25154F504F564545
!
dot11 ssid FOR_INVITE
   vlan 100
   authentication open 
   authentication key-management wpa
   mbssid guest-mode
   wpa-psk ascii 7 104C001C0B0117051901
!
!
crypto pki token default removal timeout 0
!
!
username Cisco password 7 02250D480809
!
!
bridge irb
!
!
!
interface Dot11Radio0
 no ip address
 no ip route-cache
 !
 encryption vlan 100 mode ciphers tkip 
 !
 encryption vlan 1 mode ciphers tkip 
 !
 ssid FORAMAG
 !
 ssid FOR_INVITE
 !
 countermeasure tkip hold-time 0
 antenna gain 0
 stbc
 beamform ofdm
 mbssid
 packet retries 128 drop-packet
 station-role root
 rts threshold 512
 rts retries 128
 no dot11 extension aironet
!
interface Dot11Radio0.1
 encapsulation dot1Q 1 native
 no ip route-cache
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 spanning-disabled
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
!
interface Dot11Radio0.100
 encapsulation dot1Q 100
 no ip route-cache
 bridge-group 100
 bridge-group 100 subscriber-loop-control
 bridge-group 100 spanning-disabled
 bridge-group 100 block-unknown-source
 no bridge-group 100 source-learning
 no bridge-group 100 unicast-flooding
!
interface Dot11Radio1
 no ip address
 no ip route-cache
 shutdown
 antenna gain 0
 no dfs band block
 channel dfs
 station-role root
 bridge-group 1
 bridge-group 1 subscriber-loop-control
 bridge-group 1 spanning-disabled
 bridge-group 1 block-unknown-source
 no bridge-group 1 source-learning
 no bridge-group 1 unicast-flooding
!
interface GigabitEthernet0
 no ip address
 no ip route-cache
 duplex auto
 speed auto
!
interface GigabitEthernet0.1
 encapsulation dot1Q 1 native
 no ip route-cache
 bridge-group 1
 bridge-group 1 spanning-disabled
 no bridge-group 1 source-learning
!
interface GigabitEthernet0.100
 encapsulation dot1Q 100
 no ip route-cache
 bridge-group 100
 bridge-group 100 spanning-disabled
 no bridge-group 100 source-learning
!
interface BVI1
 ip address 192.168.1.31 255.255.255.0
 no ip route-cache
!
ip default-gateway 192.168.1.110
ip forward-protocol nd
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
!
bridge 1 route ip
!
!
!
line con 0
line vty 0 4
 login local
 transport input all
!
end

 

 

 Tank you

1 Accepted Solution

Accepted Solutions

I would test these clients by configuring WPA2/AES on a SSID & see if the behavior is same.

 

HTH

Rasika

**** Pls rate all useful responses ****

View solution in original post

2 Replies 2

I would test these clients by configuring WPA2/AES on a SSID & see if the behavior is same.

 

HTH

Rasika

**** Pls rate all useful responses ****

Thank you  thats it :)

Review Cisco Networking for a $25 gift card