Hi All,
I have a problem when implementing internal DHCP on EWC using the ISR 1131 sdwan router. I configured the internal DHCP correctly but DHCP is not running. When I debug and display errors like this
*Jul 16 20:09:48.554: DHCPD: Reload workspace interface GigabitEthernet0 tableid 0.
*Jul 16 20:09:48.554: DHCPD: Sending notification of DISCOVER:
*Jul 16 20:09:48.555: DHCPD: htype 1 chaddr a81a.f100.2e35
*Jul 16 20:09:48.555: DHCPD: remote id 020a00000a29e57d40000000
*Jul 16 20:09:48.555: DHCPD: interface = GigabitEthernet0
*Jul 16 20:09:48.555: DHCPD: Sending notification of DISCOVER:
*Jul 16 20:09:48.555: DHCPD: htype 1 chaddr a81a.f100.2e35
*Jul 16 20:09:48.555: DHCPD: remote id 020a00000a29e57d40000000
*Jul 16 20:09:48.555: DHCPD: interface = GigabitEthernet0
*Jul 16 20:09:48.555: DHCPD: FSM state change INVALID
*Jul 16 20:09:48.555: DHCPD: Workspace state changed from INIT to INVALID
*Jul 16 20:09:48.555: DHCPD: classname not set in msg
*Jul 16 20:09:48.555: DHCPD: there is no address pool for 10.41.229.125.
*Jul 16 20:09:48.555: DHCPD: there is no address pool for 10.41.229.125.
*Jul 16 20:09:48.555: DHCPD: Sending notification of ASSIGNMENT FAILURE:
*Jul 16 20:09:48.555: DHCPD: htype 1 chaddr a81a.f100.2e35
*Jul 16 20:09:48.555: DHCPD: remote id 020a00000a29e57d40000000
*Jul 16 20:09:48.555: DHCPD: interface = GigabitEthernet0
*Jul 16 20:09:48.556: DHCPD: Sending notification of ASSIGNMENT_FAILURE:
*Jul 16 20:09:48.556: DHCPD: due to: NO POOL
*Jul 16 20:09:48.556: DHCPD: htype 1 chaddr a81a.f100.2e35
*Jul 16 20:09:48.556: DHCPD: remote id 020a00000a29e57d40000000
*Jul 16 20:09:48.556: DHCPD: interface = GigabitEthernet0
as additional info, the IP Management of the WLC and AP is different from the dhcp pool that I created, the WLC and AP use Vlan 100 while the dhcp pool uses vlan 103, both gateways are configured on the sdwan router.
Does the EWC version not support internal dhcp?
