04-09-2008 08:12 AM - edited 07-03-2021 03:41 PM
Hi,
I am trying to setup a guest vlan. I set up an interface for the guest vlan on my 4402 controller. I assigned the guest vlan interface an IP of 192.168.2.10 with a 24 bit subnet mask.
This vlan will go to my DMZ where there is no DHCP server so I need to setup the internal DHCP server. I created a new scope but I'm having trouble with what to put in the Network field for the DHCP scope. The pool addresses are 192.168.2.100-200. with a 24 bit subnet mask.
Every time I try to apply the configuration I get an "error in setting DHCP scope network and netmask".
I've tried using:
192.168.2.10
192.168.2.255
192.168.2.254
as entries for the Network setting but no go. The docs say to enter the IP address used by the management interface with subnet mask applied.
I was assuming they meant the interface for the guest vlan.
What am I doing wrong here?
Thanks.
04-09-2008 08:27 AM
Never mind. Once I wrote it out I saw my error.
08-06-2012 09:57 PM
I know this is an old post but could you please tell me what your solution was
08-06-2012 11:36 PM
Jason:
This is an old post with probably very old code version on the controller.
If you want help please feel free to open a new thread and explain your issue so we better help you.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: