I have a Cisco UC540 Router at my office, My network and IP phone at the office are working fine. I have 2 Vlans one for Data and one for Voice. We installed a new office 100 metes away and connect them with two AP (TL-WA5210G) on bridge mode, at the new office we are connected with the data network (file sharing, connected with the server, have internet access) but my IP phone Cisco 7942G can not acces the Voice Vlan.
Switch Port was on acces mode and the phone not discoverable from CDP, I set the Switch port to trunk mode and now i can c it on CDP neigdboors. Still the phone on DHCP enable mode get a Data vlan IP.
Table of Contents
Table of ContentsOverviewConnecting a Catalyst 9800 WLC to Cisco DNA Center ManuallyConnecting an AireOS WLC to Cisco DNA Center ManuallyCisco DNA Center Assurance Deployment Guide References
The purpose of this document...
Securing devices without 802.1X
PSK (Pre-Shared-Key) WLAN is widely used for consumer & enterprise IoT onboarding as most of IoT device doesn’t support 802.1X. While PSK WLAN provides an easy way to onboard IoT, it also introduces challenges as...
Due to the certificate expiration, any new Control and Provisioning of Wireless Access Points (CAPWAP) or Light Weight Access Point Protocol (LWAPP) connection will fail to establish. The main feature that is affected will be the Acce...
Where to download
Attached files on this post
Alternatively, cloud version (only summaries)
New implementation for the WLC Config Analyzer. it is a new re-write of the application, with clean up and improved checks
Support for IOS...