Is it possible to config a 3602e AP w/Autonomous load via GUI?

[nh6we]

I have a 3602e access point which I need to configure.  It has been loaded with an autonomous image (for survey work) and my only access currently is via a browser.  Is it possible to http into this access point if its only been imaged and not configured.

I appreciate any help

Thanks

[Scott Fella]

I believe the autonomous image has limited GUI on the 3600. We have always used the the CLI to configure the 3600 IOS

Sent from Cisco Technical Support iPhone App

[nh6we]

Thanks but do you know off hand what the default ip address is?

Chris

[Scott Fella]

Its dhcp.... there is no default ip address.  You would have to console into the ap and set an address on the bvi interface.

Thanks,

Scott

Help out other by using the rating system and marking answered questions as "Answered"

[nh6we]

Scott,

   Thanks.  I polled my DHCP server got the address, logged in and made my changes.

Thanks for the assist

Chris

[Leo Laohoo · Accepted solution]

Nice response, Scott.

+5