cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3617
Views
5
Helpful
10
Replies
Rps-Cheers
Rising star

Is there any command to check wlc power supply serial number ?

Hi,

 

I want to check wlc5508 power supply serial nummer,but we only can check the  power supply status by "show inventory" or "show sysinfo" command.

Is there any command to check the power supply serial number on CLI or GUI ?

 

Thanks

10 REPLIES 10
Haydn Andrews
Rising star

Not sure if this will work but it will get the SFP details which are not seen via the show inventory

 

show inventory raw 

or

 

debug fastpath cfgtool --dump.sfp

 

reference:

https://mrncciew.com/2014/08/18/wlc-sfp-info/

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***

HI Haydn

There is no "show inventory raw " command.
I think this mothd is not avaliable,because i have found this link to try.

Then the only variant is to pull it out. If you have two, then this should work without an interruption.
HaifengLi
Cisco Employee

Hi,

 

It is not possible to find out the power supply serial number through the WLC or via SNMP.

 

Best regards,

Haifeng

If the previous commands don't show it, then probably not.


Thanks for your reply, i also think so...

Hi Haifeng

Thanks for your response,i got it.

But,Is there any way to check the power supply serial number except for the wlc and snmp method ?

Yes, it should be printet on a label on the PSU. For this you have to remove it and check the label.




Ok, it seems that this is the only way
Content for Community-Ad