Issue Apply Dynamic Interface from Prime

[Willem de Groot]

Hi all,

I have some problems applying a Dynamic Interface Template from prime to my WLC:

Prime: 1.3.0.20 Update 4

WLC 5508 / 7.4.110.0

I can Apply this template to older WLC versions.

The LAG mode is enabled on my WLC.

Any Idea?

Willem

[Sandeep Choudhary]

what is the error you are facing???

Can you paste the screenshot.

Regards

[Willem de Groot]

If I click on "apply to controllers..." there is a list of controllers but the controller I want to apply the template to is not in this list (new controller, the first 7.4 connected to this prime, the other controllers are 4402 or 5508 all with 7.0.235.0) .

If I clear the LAG flag, there is one controller in the list but also not the one I want to apply the template to.

The controller will show up in other lists like "NTP".

I can also apply NTP Servers to this controller, what means that in general the communication is possible.

[Sandeep Choudhary]

1. is the 7.4v controller is connected to prime infra????

2. can you check again on WLC, is LAG enabled on 5508 or not ?

Regards

[Willem de Groot]

Hi I found it , if I scroll down the list I'll find it

I think I have to get used to the huge white screen part below the small scrollable Information part

[Sandeep Choudhary]

Great that finally you scrolled down to check it. Same things happened with me when frist time I was configuring WLC via WCS.

Regards

Dont forget to arte helpful posts and mark the question as answered, it may help others.