02-16-2012 04:34 AM - edited 07-03-2021 09:35 PM
I have 2 1131AG LWAPP AP's purchased in the UK connecting to a WLC 5508 in the US that is setup only for Country US. I am getting the above error when trying to add Country GB United Kingdon I get an error that 802.11b and 802.11a are enabled and must be disabled to use this country code. I am not sure if there is a workaround for this because I do not want to disable these networks.
02-16-2012 04:36 AM
Well you need to disable them temporarily to allow you to set the other country code. Once set, you can enable the 802.11a and 802.11b radios globally again.
12-19-2013 03:26 PM
download wlc configuration guide again. and see index global mode.
12-20-2013 07:35 AM
Here is the method to change country code:
GUI:
Step 1 Follow these steps to disable the 802.11a and 802.11b/g networks as follows:
a. Choose Wireless> 802.11a/n > Network.
b. Unselect the 802.11a Network Status check box.
c. Click Apply to commit your changes.
d. Choose Wireless > 802.11b/g/n > Network.
e. Unselect the 802.11b/g Network Status check box.
f. Click Apply to commit your changes.
Step 2 Choose Wireless > Country to open the Country page
Step 3 Select the check box for each country where your access points are installed. If you selected more than one check box, a message appears indicating that RRM channels and power levels are limited to common channels and power levels.
Step 4 Click OK to continue or Cancel to cancel the operation.
Step 5 Click Apply to commit your changes.
Step 6 Reenable the 802.11a and 802.11b/g networks
By CLI:
Before you can change the country code of a WLC, you must disable the 802.11a and 802.11b network :
>config 802.11a disable network
>config 802.11b disable network
Now you can change the country code of the controller. For example, we change it from US to IN (INDIA)
>config country GB
After changing the country,enable the 802.11 interfaces.
>config 802.11a enable network
>config 802.11b enable network
Regards
Dont forget to rate helpful posts.
12-20-2013 02:36 PM
world mode wlc configuration join controller.. contact with cisco TAC engineering call 18005532447. TAC team help you within minute.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide