Re: Issue with Access Points Functioning as Repeaters Post-Update

Repeater-mode · ‎02-19-2024

Hi all,

Following the latest update, some of the APs have unexpectedly transitioned into repeater mode. Despite performing reboots on the affected units, the problem persists, with the APs persistently acting as repeaters.

This deviation from their prior functionality is concerning, especially considering that all units were operating correctly before the update.

I'm reaching out to inquire if any of you have encountered similar challenges post-update. Please share any observations or suggestions you might have regarding this matter.

It's 4 out of 187 AP's acting this way..

aleabrahao · ‎02-19-2024

I suggest you open a support case.

I am not a Cisco employee. My suggestions are based on documentation of Meraki best practices and day-to-day experience.

Please, if this post was useful, leave your kudos and mark it as solved.

Rasmus Hoffmann Birkelund · ‎02-19-2024

Perhaps disable Meshing on the Network-Wide configuratino page, if you don't want Meraki to automatically mesh incase of missing uplink connection.

#########
LinkedIn ::: https://blog.rhbirkelund.dk/
Like what you see? - Mark as helpful ## Did it answer your question? - Mark it as a Solution 🙂
All code examples are provided as is. Responsibility for Code execution is solely your own.

ppurroy · ‎02-19-2024

You might be hitting the condition discussed in this thread:

https://community.meraki.com/t5/Wireless-LAN/Firmware-Network-Issue-MR30-5/m-p/220995#M30594