cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
590
Views
0
Helpful
3
Replies

LAP1041 LED off

minwangaip
Beginner
Beginner

I have two LAP1041 with WLC2504 everything works fine. But since yesterday when it boots up it flashes green, then solid green, then after about 10 seconds the green LED turns off, however the LAP is still working fine, Why is that?  If I put my eyeball up close to the LED I see dim red inside the LED plastic cover.                  

3 Replies 3

Scott Fella
Hall of Fame
Hall of Fame

On the WLC CLI issue: config ap led-state enable all

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

worked! thank you!

No problem!

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: