Lightweight AP disable console logging

[Philip91]

Hello Guys,

how can i disable logging, when i am connected to an LWAP via console ?

I guess on a switch its something like "no logging console".

Is there a Lightweight AP CLI command reference ?

Thanks for help !

Greetings

[Rasika Nayanajith · Accepted solution]

Try "debug capwap console cli" command & then apply "no logging console" command as shown below

APbc16.6516.790e#debug capwap console cli

This command is meant only for debugging/troubleshooting

Any configuration change may result in different

behavior from centralized configuration.

CAPWAP console CLI allow/disallow debugging is on

APbc16.6516.790e#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

APbc16.6516.790e(config)#no logging console

HTH

Rasika

[Rasika Nayanajith]

Here are the WLC CLI command references (for 5508,2504, WiSM)

http://www.cisco.com/en/US/customer/products/ps10315/prod_command_reference_list.html

Here is the IOS XE CLI command reference (for 5700/3850)

http://www.cisco.com/en/US/customer/docs/wireless/controller/3.2_0_se/multibook/command_reference/b_consolidated_command_reference_chapter_01100.html

HTH

Rasika

[Kunal Kumar Singh]

The command is not working on 3802i .. what the new command to get into config t mode and also delete nvram. 

[davidpoole1]

I can get onto the 3802i but I don't see all of the cli commands

how do I view those

[Sathiyanarayanan Ravindran]

Login in to AP and go to enable mode use the command

login as: test
test@xx.xx.xx.xx's password: Enter login password
LABAP>en
Password: Enter enable password
LABAP#logging console disable

[Kunal Kumar Singh]

Command is no more supported on 3802i as these controller can also be configured as mobility Express. Workaround is to load mobility express image on these AP and configure Mobility controller. once done. Same AP will also join as AP under mobility controller. ( Concept is similar as Autonomous WDS where an AP act as both WDS Server and AP that participate).  Once AP join . You can configure AP for standalone for wireless site survey purpose.

[Alejandro Josue Barquero Bustos]

Helping 13 years after!

[zjohnson1]

Rasika you are my Hero. After hours of searching it was your Post that saved me! THANK YOU!

[Rasika Nayanajith]

Great to see this help you out ;)

Rasika

[ahervey]

logging console disable