10-30-2019 07:31 PM - edited 07-05-2021 11:13 AM
Hello Everybody,
I have a question about LLDP with 3802AP
I found 3802AP supports CDP and LLDP.
However, I could not find any configuration about lldp.
I tired to type the config such as lldp run, show lldp, config lldp etc..
but, there is only cdp config.
Does disabling a cdp mean enabling a lldp in AP?
Thank you.
Solved! Go to Solution.
10-30-2019 07:48 PM
@Haydn Andrews wrote:
You would need to enable LLDP on the switch though
Depends on the switch and depends on the firmware.
Classic IOS have no issues with CDP and LLDP enabled.
IOS-XE running 3.X.X have no issues with CDP and LLDP enabled.
Starting from 16.X.X (and later), TAC does not recommend enabling CDP and LLDP together in a switch.
10-30-2019 07:42 PM
from memory if CDP is enabled on the AP then so is LLDP
You would need to enable LLDP on the switch though
10-30-2019 07:48 PM
@Haydn Andrews wrote:
You would need to enable LLDP on the switch though
Depends on the switch and depends on the firmware.
Classic IOS have no issues with CDP and LLDP enabled.
IOS-XE running 3.X.X have no issues with CDP and LLDP enabled.
Starting from 16.X.X (and later), TAC does not recommend enabling CDP and LLDP together in a switch.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide