09-06-2011 02:20 AM - edited 07-03-2021 08:40 PM
Hi
I have a Cisco controller WLAN solution where I want to bridge traffic locally on a remote site, when using Cisco 1140 LWAPP.
Is the only way H-REAP ?
Thank´s for help !
Regards
Erik
09-06-2011 02:31 AM
Hi Erik,
yes HREAP will be the only way to do local bridging.
regards
Stefan
09-06-2011 06:39 AM
Ok thank´s
I am reading about Local-MAC and Split-MAC and i am a little confused if this is regarding H-REAP or just ways to configure the CAPWAP tunnel ?
09-06-2011 07:34 AM
Welcome!
HREAP allows you two mode of operation.
LOCAL SWITCH or CENTRAL SWITCH ...
LOCAL SWITCH mode take the traffic genterated at the loacl site and drops it right in the remote sites switch the ap attaches to. This is ideal should the site lose connection. In addtion, DHCP is handle locally. One problem with this design is 802.1X. If you lose connect to the CORP where your radius is at then you can auth users.
CENTRAL SWITCH mode take all the traffic back to corp switch where the traffic is routed.
Make sense?
If you find this helpful please support the rating systeme! We appreciate it !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: