cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3539
Views
5
Helpful
7
Replies

Mobility Express- Cisco AP 2800

Dears,

 

I need your help in checking an issue with 2800 AP in mobility express.

 

I have a Master 2800 AP and want to Join another 2800 AP to this Master AP, noting that this new AP is running the mobility express image not capwap, is this possible or i should convert it?

 

Looking forward to hearing from you.

 

Regards,

Muhannad

1 Accepted Solution

Accepted Solutions

Ric Beeching
Level 7
Level 7

Hi Muhannad,

 

I think you can do either. If two ME APs are in the same subnet then they will go through a master election process and, once determined, the other AP will join it as a subordinate.

 

I assume if you configure it as CAPWAP then that removes the possibility of it becoming the master / an ME WLC and it will join the first AP as a normal AP.


Good luck!
Ric

 

-----------------------------
Please rate helpful / correct posts

View solution in original post

7 Replies 7

Ric Beeching
Level 7
Level 7

Hi Muhannad,

 

I think you can do either. If two ME APs are in the same subnet then they will go through a master election process and, once determined, the other AP will join it as a subordinate.

 

I assume if you configure it as CAPWAP then that removes the possibility of it becoming the master / an ME WLC and it will join the first AP as a normal AP.


Good luck!
Ric

 

-----------------------------
Please rate helpful / correct posts

Dear Ric,

 

Many thanks for your answer so this is supported, i can join an AP running Mobility express image to the master AP.

 

Regards,

Muhannad

Hi Muhannad,

 

That is my understanding, yes.

 

Thanks,

Ric

-----------------------------
Please rate helpful / correct posts

mindgame71
Level 1
Level 1

Dear Muhannad

 

I have excactly the same situation. I have a small existing deployment with a 2800i - ME - as a Master AP and a 2700i as a CAPWAP.

 

Now to extend the Wireless Network I want to add a second 2800i - ME - so that we have a second Master AP if the first fails.

But if I want to add the second Mobility Expreess AP my new AP is running in a bootloop:

...

[*05/15/2018 13:40:31.4524] Last reload reason : 3: Detected another ME controller.
...

 

I am using the Software Version 8.5.105.0. Did you have similar experience? What Software Version are you using?

 

I have a discussion for my issue:

https://supportforums.cisco.com/t5/other-wireless-mobility-subjects/mobility-express-2800i-adding-new-moe-wlc-ap-to-existing/m-p/3384720#M84257

 

Thanks for an answer and best Regards

Oliver

Thanks Oliver for sharing this with me.

Dear Olivar,

 

I have used version 8-5-120-0, the first controller was up and running when i have joined the second ME to the network, it was able to detect the primary ME and joined as subordinate.

 

Regards,
Muahnnad

Dear Muahnnad

Thanks a lot for your reply.

Best Regards

Oliver

 

Review Cisco Networking for a $25 gift card