02-12-2018 03:38 AM - edited 07-05-2021 08:14 AM
Dears,
I need your help in checking an issue with 2800 AP in mobility express.
I have a Master 2800 AP and want to Join another 2800 AP to this Master AP, noting that this new AP is running the mobility express image not capwap, is this possible or i should convert it?
Looking forward to hearing from you.
Regards,
Muhannad
Solved! Go to Solution.
02-12-2018 03:46 AM - edited 02-12-2018 03:50 AM
Hi Muhannad,
I think you can do either. If two ME APs are in the same subnet then they will go through a master election process and, once determined, the other AP will join it as a subordinate.
I assume if you configure it as CAPWAP then that removes the possibility of it becoming the master / an ME WLC and it will join the first AP as a normal AP.
Good luck!
Ric
02-12-2018 03:46 AM - edited 02-12-2018 03:50 AM
Hi Muhannad,
I think you can do either. If two ME APs are in the same subnet then they will go through a master election process and, once determined, the other AP will join it as a subordinate.
I assume if you configure it as CAPWAP then that removes the possibility of it becoming the master / an ME WLC and it will join the first AP as a normal AP.
Good luck!
Ric
02-12-2018 05:13 AM
Dear Ric,
Many thanks for your answer so this is supported, i can join an AP running Mobility express image to the master AP.
Regards,
Muhannad
02-12-2018 05:14 AM
Hi Muhannad,
That is my understanding, yes.
Thanks,
Ric
05-17-2018 01:33 AM
Dear Muhannad
I have excactly the same situation. I have a small existing deployment with a 2800i - ME - as a Master AP and a 2700i as a CAPWAP.
Now to extend the Wireless Network I want to add a second 2800i - ME - so that we have a second Master AP if the first fails.
But if I want to add the second Mobility Expreess AP my new AP is running in a bootloop:
...
[*05/15/2018 13:40:31.4524] Last reload reason : 3: Detected another ME controller.
...
I am using the Software Version 8.5.105.0. Did you have similar experience? What Software Version are you using?
I have a discussion for my issue:
Thanks for an answer and best Regards
Oliver
05-20-2018 01:25 AM
Thanks Oliver for sharing this with me.
05-20-2018 04:42 AM
Dear Olivar,
I have used version 8-5-120-0, the first controller was up and running when i have joined the second ME to the network, it was able to detect the primary ME and joined as subordinate.
Regards,
Muahnnad
05-22-2018 02:36 AM
Dear Muahnnad
Thanks a lot for your reply.
Best Regards
Oliver
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide