Mobility Express first connection

[babdoul11]

Hi all, 

i would like help for my first post.

I want to use Mobility Express on 1830 access point. the fact is that it's for a distant site (not even same continent) and i want to send access point directly onsite after ordering. by doing so after having it connected in local swith (where i have acces and with DHCP server) will i be abble to configure access points at distance?

Will access points with Mobility express get automaticly get DHCP address and allow me to configure Wlan, master and slave etc...?

Thank you.

[Sandeep Choudhary]

I dont think its possible.

First you need to configure the basic things (mgmt ip/ mask/ username/password)

Once this is done then you can connect to swicth port and can configure it remotely.

Bets way would be:

1. Ask someone form remote site to give you a console acces to AP

2. confifure basic parameter/startupconfig(just like WLC)

3. Connect AP to swicthport and finish config from your home location.

Regards

Dont forget to rate helpful posts

[patoberli]

Don't do this, or at least make sure you buy an AP for the destination country, or it will not work when selecting the wrong country!
See here for more information: https://www.cisco.com/c/dam/assets/prod/wireless/wireless-compliance-tool/index.html
I suggest you do the basic setup in your office (create SSID and PSK, other few settings) and then send it. This should work.