08-06-2018 01:44 PM - edited 07-05-2021 08:56 AM
Hi,
i try to configure 2800 with Mobility Express (ME) configuration connected to a switch on which is not possible to have a trunk port (802.1q). So I am in access port. I am using 8.5.x release and I have only one AP in ME (so it is master ME)
I have found on controller configuration (CLI) this command:
config ap flexconnect vlan disable
I didn't find sample configuration for ME with access port. So I might be wrong about the configuration.
All seems to be ok until I setup a VPN tunnel on a PC already connected to the AP. I use Cisco Anyconnect and I see connection/reconnection and VPN tunnel is not able to setup. I suppose this is a problem due to this access port configuration (MTU, VPN pass through issue...).
So, any recommendation would be appreciated on ME with Access port configuration.
Thanks
Stephan
08-06-2018 02:00 PM
08-06-2018 02:56 PM
08-06-2018 03:11 PM
Hi
In this case, This is no problem config 2 WLAN to separate 2.4 and 5g client as you configured.
client throughput point of view, this is recommended.
Thanks
08-06-2018 10:54 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide