Re: Mobility express- WLC as AP

prestigio391 · ‎07-06-2021

HEllo guys is possible broadcast SSID from AP that is configured as WLC in mobility express ?

Karsten Iwen · ‎07-06-2021

Yes, the AP configured as an ME controller still functions as a "normal" AP in addition to the controller function.

--
If you found this post helpful, please give it Kudos. If my answer solves your problem, please click Accept as Solution so others can benefit from it.

Mark Elsen · ‎07-06-2021

- It should do so by default.

M.

-- Let everything happen to you
   Beauty and terror
      Just keep going
     No feeling is final
Reiner Maria Rilke (1899)

Rich R · ‎07-06-2021

Have you made sure that your DHCP is working - the AP still needs to get an IP address in addition to the WLC IP which can be static or DHCP?

------------------------------
Please click Helpful if this post helped you and Accept as Solution (drop down menu at top right of this reply) if this answered your query.
------------------------------
TAC recommended codes for AireOS WLC's and TAC recommended codes for 9800 WLC's
Best Practices for AireOS WLC's, Best Practices for 9800 WLC's and Cisco Wireless compatibility matrix
Check your 9800 WLC config with Wireless Config Analyzer using "show tech wireless" output or "config paging disable" then "show run-config" output on AireOS and use Wireless Debug Analyzer to analyze your WLC client debugs
Field Notice: FN63942 APs and WLCs Fail to Create CAPWAP Connections Due to Certificate Expiration
Field Notice: FN72424 Later Versions of WiFi 6 APs Fail to Join WLC - Software Upgrade Required
Field Notice: FN72524 IOS APs stuck in downloading state after 4 Dec 2022 due to Certificate Expired
- Fixed in 8.10.196.0, latest 9800 releases, 8.5.182.12 (8.5.182.13 for 3504) and 8.5.182.109 (IRCM, 8.5.182.111 for 3504)
Field Notice: FN70479 AP Fails to Join or Joins with 1 Radio due to Country Mismatch, RMA needed
Field Notice: FN74383 APs Running 17.12.4/5/6/6a May Run Out of Flash Space Preventing Upgrades
How to avoid boot loop due to corrupted image on Wave 2 and Catalyst 11ax Access Points (CSCvx32806)
Field Notice: FN74035 - Wave2 APs DFS May Not Detect Radar After Channel Availability Check Time
Leo's list of bugs affecting 2800/3800/4800/1560 APs
Default AP console baud rate from 17.12.x is 115200 - introduced by CSCwe88390

prestigio391 · ‎07-06-2021

Hello, Thanks for answer, Problem ist that in Cisco ME version 8.10.151 i cant se ME ap like typical AP for SSID broadcast..When i try command apciscoshell i still jump to (Cisco COntroller ) > not to AP# mode

Mark Elsen · ‎07-06-2021

- You have to setup wlan-parameters through the GUI , which will then apply to the controller-ap too (ssid broadcasting).

M.

-- Let everything happen to you
   Beauty and terror
      Just keep going
     No feeling is final
Reiner Maria Rilke (1899)