cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2236
Views
3
Helpful
8
Replies

Move multiple APs from one primary controller to secondary

jbc-ktm
Level 1
Level 1

Hello.

We have an environment consisting of 2 Cisco 9800 WLC. One primary and the other secondary.

In addition, we have approximately 800 Access Points. All 800 use the primary controller. I just upgraded the secondary controller and now the primary needs to be upgraded. Therefore I need to move all the APs from the primary to the secondary.

I do this one AP at a time under the High Availability tab, where I write the IP address of the secondary. It works fine. But the question is, is there an easier way to do it? For example, can I move a whole group of APs at a time?

The APs are divided into groups under their locations. For example "Building 1" and "Building 2".

Thanks in advance

1 Accepted Solution

Accepted Solutions