MR78

[ezaiello]

Hello Team, I hope all is well.

I need to add the MR78 to my Network. I cannot do it on the dashboard: https://n508.meraki.com/ezaiello_wireles/n/5J2Clcewb/manage/usage/list and on my list of devices, I have MX68 & MR44 https://devices.cisco.com/setup/network/wifi-config

I must set up the MR78 and leave it downstairs as the signal is too weak.

I appreciate your help,

Thank you

Ezequiel

[ww^]

Could you explain what step of adding your ap your at? And what error you get?

https://documentation.meraki.com/General_Administration/Inventory_and_Devices/Adding_and_Removing_Devices_from_Dashboard_Networks#Adding_Devices_to_Networks

[ezaiello]

I am not able to add it. What are the steps I should follow to add it?

[ww^]

You should go the the inventory, claim the order /serial.

Then the device should be seen in the inventory, then you can add that device to the network

[ezaiello]

Again, I do not see the inventory. I opened a case at Cisco and they told me to reach out to you. Any chance we can do a WebEx to check this?

[aleabrahao]

@ezaiello the @jdb1 and I are not Meraki employee. You can read the documentation and follow the steps.

https://documentation.meraki.com/General_Administration/Inventory_and_Devices/Using_the_Organization_Inventory

If you are not able to se the inventory, probably you are not organization admin.

[GreenMan]

I believe you've been directed to the wrong place for assistance. You do not have appropriate admin rights. I will DM you