MSE not showing Clients on PI maps (PI 3.1, vMSE 8.0.140 & WLC 8.3.133)

[David Ritter]

While the MSE reports 4967 active clients, none are displayed on PI maps.  Only rogue's and interferers.

Client Filter is set for Show All and MSE does display Probing clients but not the attached and authenticated.  Left Click the AP and they report plenty of clients attached.

"Show MSE data" is set for Currently Detected.

[iamnothere123 · Accepted solution]

I suggest upgrading to PI 3.3 if possible!

https://www.cisco.com/c/en/us/support/cloud-systems-management/prime-infrastructure/products-installation-guides-list.html 

[David Ritter]

that will in fact happen. The 'wired' team is in command and they are not ready yet.

[iamnothere123]

I understand!!