12-08-2011 11:46 AM - edited 07-03-2021 09:12 PM
Hi all.
My boss just asked me if there was a way for him to move from point A to Point B with his wireless laptop and
NOT have to reauthenticate at point B if I install another access point there. Right now I have us setup on a
Cisco WAP4410N Access Point that works well when he's within range of the antenna. The point B
location is upstairs and while it's only about 50-70 feet away from the Point A access point the
signal he's getting there is very weak so he wants me to install another AP there.
IOW he wants to authenticate once at point A and when he walks up to point B he wants the laptop to
pickup the newer hotter signal when I put another AP point in.
Is this possible?
I was looking at the client/repeater tabs in the firmware.
Thanks.
Frank Tierno
Solved! Go to Solution.
12-08-2011 12:00 PM
Here is an older post regarding the WAP4410N
https://supportforums.cisco.com/message/3078024#3078024
Sent from Cisco Technical Support iPhone App
12-08-2011 12:00 PM
Here is an older post regarding the WAP4410N
https://supportforums.cisco.com/message/3078024#3078024
Sent from Cisco Technical Support iPhone App
12-08-2011 12:55 PM
Thanks. Will try some of these suggestions.
We do use CDW btw.....
12-08-2011 01:03 PM
Well I hope that the CDW engineer knew that:)
Sent from my iPhone
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide