Wireless

Hi there all When you set users up on LA and you set a user to a "controller list", the entry on the listing always shows the account as active from the front menu even if the time has expired.You then go into the account and you can see the date has...

Does anyone know any more about the ETA for this fix? The problem is that APs will stop sending beacons for several seconds, causing clients to obviously become unhappy. The bug shows a fix in a forthcoming realease, but no ETA. This sucker is nas...

Hello all, I have aquestion about a 1310 wireless bridge we have installed on top of a 9 story building. It is connected to the injector with a 100ft and a 50ft section of twinax cable with a barrel connector in between them. It has been operating fo...

Hi Guys,I have to do a wireless bridge with 2 AIR-BR1310G-E-K9. I configure 1 AP root bridge and 1 AP non-root bridge, with the same SSID.But on the AP non-root bridge, the interface dot11 radio don't change it state to up and give this error: %DOT11...

Thanks to confirm that AP521 need a Cisco 520 Switch. And that it cannot works without Cisco product.

Hi all, I have a problem with a P2P Bridge with a couple of Aironet 1242AG.Sometimes this Bridge goes down, and if I change Channel, it goes up.When Bridge is down I can see this log in NoRoot:*Apr 23 04:12:20.002: %DOT11-4-UPLINK_ESTABLISHED: Interf...

When I take a look in the deployment guides I could see that I should not use data rates in the 802.11a network below 12mbit. We do not expect more than 6 calls and 8 phones on one access point but would like to raise the coverage by using 6mbit data...

Is there any Cisco white papers or configuration guides for LWAPP in 'rogue detection' mode.Thanks

Is there a "rule-of-thumb" for the lease of DHCP on a guest or general use wireless network. The standard user is expected to be relatively transient. Thanks in advance for the comments / help.

We have one 4404 with 100 managed accesspoints. Now we are going to buy two 5508 to replace the 4404.Hopefully we can join the two new 5508 to the existing configuration, move the acesspoints to then and then "disjoin" the old controller.Is there any...

Guys, I wonder, if anyone has faced similar issues. 1. Clients get connected to a farther AP rather than AP inside the room . Ping rate differs between clients , which means for eg: in real Thinkpad X61 with Athero Adapters perform better latency lik...

Is it possible to terminate non-web-auth WLANs on an anchor controller?For example, you want to segregate particular WLAN access but still have encryption using WPA2-PSK or WPA2-ENT with 802.1x etc.Thanks.

Environment:1. 1 building2. 6 floors3. 8 1142 APs per floor4. APs no more than 50' apart5. 2 4404 WLCsBackground:I have disabled all of the data rates below 48Mbps, set 48Mbps to Require, and set 54Mbps to Supported. After walking around and surveyi...

I am using HWIC-AP module in 1841 router to allow wireless clients to connect to LAN. Is there a way of hiding the SSID broadcast?

I have the need to install 1140 APs..I have a large 4.2 environment with guest wireless. I am stuck on 4.2 with a couple sites with a lot of 1010 AP's.. Can I run 6 on a WLC and still mobility peer to a 4.2.207 WLC and anchor the guest WLAN?