WAP question.
Have a customer with a LAN made up of three 3750s in different locations trunked together. Got a WLC for vlan 130 and ip range 192.168.130.0. .5 is the IP on the WLC.
In one of the locations the WAP stopped working. It would cycle through red/amber/green constantly and quickly. I figured WAP was bad as tech took a working WAP from another location and plugged it in and it was working.
I took them a brand new, boxed, WAP. Exact same problem. They swapped the new but not working WAP for one that was working at a different location. That one works at disabled WAPs location and the non working WAP doesn't work at the working WAP's previous location.
It also cycles through colors very quickly. The ethernet and radio LED will be green momentarily and then turn off or go amber. The WAP will broadcast a radio signal for about 10 seconds before it turns from green to the cycle.
Any ideas before I drive way out there myself?