- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-11-2012 12:49 AM - edited 07-03-2021 10:38 PM
HI
my ncs server is restart,but the NCS can not start DB.AND Can't use WEB interface access.
the status:
PCQ-NCS-01/admin# ncs status
Health Monitor is running, with an error.
initHealthMonitor(): can not start DB
Reporting Server is Stopped
Ftp Server is Stopped
Database server is stopped
Tftp Server is Stopped
Matlab Server is Stopped
NMS Server is stopped.
PCQ-NCS-01/admin# ncs start
Starting Network Control System...
This may take a few minutes...
Health Monitor is already running.
Failure during Network Control System startup. Check launchout.log for details.
the show-tech file
what happern?
Solved! Go to Solution.
- Labels:
-
Wireless Network Management
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-11-2012 08:24 PM
Hailin,
Did an SSH session happen to time out while you were in the process of upgrading or performing other actions?
Hopefully you have the NCS backed up.
To get it back up and running do the following from the CLI.
1. Stop the NCS
2. Run 'ncs db reinitdb'
3. Start the NCS
***WARNING*** You may lose database information but with this you
should be able to get the NCS back up and running.
Regards,
Aaron

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-11-2012 08:24 PM
Hailin,
Did an SSH session happen to time out while you were in the process of upgrading or performing other actions?
Hopefully you have the NCS backed up.
To get it back up and running do the following from the CLI.
1. Stop the NCS
2. Run 'ncs db reinitdb'
3. Start the NCS
***WARNING*** You may lose database information but with this you
should be able to get the NCS back up and running.
Regards,
Aaron
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-01-2012 11:54 PM
Hi Hailin,
I'm experiencing 100% same problem here after rebooting.
Have you resolved the issue?
Cheers
Jeong
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-19-2015 08:39 AM
I have the same problem too. PI version is 1.3. PI have not been working after rebooting hardware appliance. I have been receiving same message like hailin huang when I use command ncs status.
