01-06-2013 07:41 PM - edited 07-03-2021 11:18 PM
Is possible to monitor an NCS servers status via snmp (ie memory usage, disk space etc)? I've been through the NCS server setup and I can find all the references for "SNMP credentials" but the NCS server appears to only use these from rouge AP detection. It there a specific location to set the NCS Server SNMP community string to allow polling of the server status via snmp?
Solved! Go to Solution.
01-06-2013 10:33 PM
From the CLI you need to configure the SNMP configuration.
snmp-server host
snmp-server community
see this:
Regards,
Amjad
Rating useful replies is more useful than saying "Thank you"
01-06-2013 10:33 PM
From the CLI you need to configure the SNMP configuration.
snmp-server host
snmp-server community
see this:
Regards,
Amjad
Rating useful replies is more useful than saying "Thank you"
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: