cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
228
Views
0
Helpful
2
Replies

NCS - using WLAN template to configure controllers

Difan Zhao
Contributor
Contributor

Hi experts,

I can't see the dynamic interface for the WLAN that I am trying to create. The dynamic interfaces are manually configured on the controllers, not via NCS. Is there a way to let them show in the dropdown list? Do I need to create the interface and/or the interface group through the NCS as well to let them shown?

Thanks!

Difan

1 Accepted Solution

Accepted Solutions

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

Take a look at this link as it should help.

http://www.cisco.com/en/US/docs/wireless/ncs/1.0/configuration/guide/ctrlcfg.html#wp1075746

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

View solution in original post

2 Replies 2

Scott Fella
Hall of Fame Guru Hall of Fame Guru
Hall of Fame Guru

Take a look at this link as it should help.

http://www.cisco.com/en/US/docs/wireless/ncs/1.0/configuration/guide/ctrlcfg.html#wp1075746

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

Thank you scott as always

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers